Airflex Magma Instant Heater
-
Magma inline heater for use with Airflex extractors -
Adjustable temperature control (max 110 degrees) -
Steaming hot water direct from cold water in the tank -
PowerS through heavy/greasy soiling -
90 seconds warm-up time -
Includes 60″ solution hose to connect to your machine
List price: €915
Introducing Airflex Magma Inline ‘Instant’ Heater
Airflex Magma is quite simply the best performing in-line heater on the market for professional carpet cleaning machines – bar none.
Design input from two of the World’s leading heater manufacturers
With design input from two of the World’s leading heater manufacturers, it’s no surprise Magma is no ordinary in-line heater.
The first difference you’ll notice is the weight. Magma is a heavier inline heater. But isn’t this a disadvantage? Not if you want maximum heat:
Magma heaters contain more metal, which gives you better heat transfer, and a very clever internal design that gives you even more heat, plus less temperature fluctuation when cleaning.
Hot water straight from cold with no preheating needed
The next thing you’ll notice is the amount of heat you get with stone cold water in the tank of your machine.
With most inline heaters, you are lucky to get barely warm water if you start with cold water in the tank. However, with the Magma heater, you really can get consistent hot water direct from cold.
Allow Magma to warm up, then start cleaning at up to 350psi. When the water starts coming through carefully check the brass quick connects – BE CAREFUL, they will be hot!
Now continue to clean, making 4 normal passes with the wand, followed by 4 dry passes. Cleaning in this way allows the heater to keep up and gives you consistently hot water at the wand.
But with the control you need
The problem with having a fantastic heater is that lots of heat is not always a good thing. For example, when cleaning heat sensitive fabrics.
Most heaters are not adjustable so the risk of damage can be a problem when cleaning delicate fabrics with the heater on.
The Magma heater is fully adjustable. So if you’re worried about too much heat? No problem. Just turn it down.
Super tough roto-moulded casing
The Magma 4 is now built with a super tough new roto-molded casing, with all connections to the heater casting safely protected inside. Some inline heaters are built within a sealed unit, so that if a component fails you have to go out and buy a whole new heater. The Magma heater is fully serviceable, so if the heater element eventually fails, it can easily be replaced at a tiny fraction of the cost of having to buy a whole new heater.
See the Magma in action:
Click here for Magma heater video link
| Immersion heater | Magma inline heater | |
| Instant heat? | Approx 70 minutes to heat 55 litres of water from 25 to 65 degrees with 3 KW element! | Once warmed up (about 3 minutes) you have a constant supply of hot water |
| Maximum temp | 65 degrees (hotter than this damages the pump and voids the warranty on Pumptec pumps) | 110 degrees (heater is after the pump so can be much higher) |
| Heat loss between machine and wand | Loss of heat as you move further away from the machine | Heater can be positioned close to the wand for maximum heat |
